Finished and unfinished edges on notches

Finished and unfinished edges on notches

A few weeks ago, we made it possible to add splashes to bump-outs in CounterGo. But, when we did that, we also sneaked in a way to add unfinished edges to notches. This is especially useful if you’re working around columns with a countertop.

When you’re on Step 3 of a CounterGo drawing, click on a corner with a notch, and choose the type of edge you want.

Unfinished corner notch

It’s also possible to change the type of edge if you’ve got a bump-in somewhere else on the countertop. In that case, you’ll first need to Segment This Edge when you’re on Step 3. For each of the segments of the bump-in, you can decide whether it has a finished edge, unfinished edge, or a backsplash.

Unfinished bump-in

Want to know more? At Moraware, we make software for countertop fabricators. CounterGo is countertop drawing, layout, and estimating software. JobTracker is scheduling software that helps you eliminate the time you waste looking for job folders. RemnantSwap is a free place to buy and sell granite remnants with fabricators near you. We also sponsor StoneTalk, the podcast for countertop fabricators.

Leave a Reply

Your email address will not be published. Required fields are marked *